CPDEVICE APOLLO7 PRO Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Desktop CPDEVICE APOLLO7 PRO. CPDEVICE APOLLO7 PRO 9 halaman.

CPDEVICE COPYRIGHT

5. Power On Method

All CP products are powered on and start up in the same manner. For taking power, three signal

lines are used: B+, B-, and ACC. During startup, connect B+ and ACC to the positive stage of the

power supply, and B- to the negative stage. There is a wide-voltage input on the tablet of 9-36V,

and a power supply of at least 2A is recommended. Following is a diagram of the recommended

power supply. Using the above method of taking power is beneficial in controlling the standby

current of the entire machine, reducing the risk of data loss caused by sudden power failure of the

tablet, and reducing the risk of the machine being burned out due to poor contact of the physical

switch during booting.

APOLLO

6. Connection of APOLLO to PC

The APOLLO series only support USB2.0, thus a USB2.0 cable will be required to

connect the PC and tablet The USB2.0 male-to-male debugging cable is

recommended.

After selecting the correct cable, you should connect both ends to the USB ports on

your PC and tablet. For firmware programming or debugging, please change the USB