DFRobot DFR0162 Manual - Halaman 2

Jelajahi secara online atau unduh pdf Manual untuk Motherboard DFRobot DFR0162. DFRobot DFR0162 3 halaman.

Specifications

MCU: Atmega328P low voltage version (16Mhz)

Ethernet: WIZ 5100

Arduino Uno bootloader

Supply voltage:5~12v

Output voltage:5v/3.3v

Digital IO: 8

Analog In: 8

Envionment Friendly: Rohs Compliance

Informational LED

PWR: indicates that the board and shield are powered

LINK: indicates the presence of a network link and flashes when the shield transmits or receives data

FULLD: indicates that the network connection is full duplex

100M: indicates the presence of a 100 Mb/s network connection (as opposed to 10 Mb/s)

RX: flashes when the shield receives data

TX: flashes when the shield sends data

COLL: flashes when network collisions are detected

Xboard V2 Pinout Diagram

Connection Diagram

This connection diagram shows how to connect the FTDI programmer to the X-board for uploading an Arduino

sketch.

NOTE: Please select "arduino UNO" from the boards list in the Arduino IDE.