Avsl 172.114UK Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penguat Avsl 172.114UK. Avsl 172.114UK 3 halaman. 1u stereo power amplifiers

Halaman Cetak

Setup

Connect the supplied power lead to the rear IEC inlet of the PL-series amplifier (11) and plug the other end into

a mains power socket, ensuring the correct voltage at the outlet.

Ensure that the cooling vents at front and rear (10) are not covered or obstructed in any way with adequate

space for air-flow through the unit.

Operation

With CH A and CH B volume controls (3, 5) turned fully down (anti-clockwise), switch on the power (1) and the

LED POWER indicator will light (4)

Playing the input signal into CH A and CH B inputs (6, 7), gradually increase the CH A and CH B volume

controls. The amplified signal should be heard through the speakers and the SIG indicators (4) should respond

to the audio output. Increase the volume controls to the required level.

Alongside the SIG indicators are CLIP indicators, which should only light very briefly on the loudest transients or

spikes in the audio. If the CLIP LEDs light for more than a fraction of a second at a time, the volume controls

should be turned down or input signal will need to be reduced.

Before powering down, turn down the volume controls to avoid loud pops or noises through the speaker

Specifications

Power supply

Fuse

Power RMS @ 8Ω

Power RMS @ 4Ω

Input connections

Output connections

Frequency response

THD +N

Damping factor

S/N ratio (A weighted) : line

Slew rate

Input impedance

Output circuit architecture

Protection

Indicators

Controls

Dimensions

Weight

Disposal: The "Crossed Wheelie Bin" symbol on the product means that the product is classed as Electrical or

Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life.

The goods must be disposed of according to your local council guidelines.

PL1400

230Vac, 50Hz (IEC)

T10AL (250V)

2 x 380W

2 x 700W

Combo jack/XLR balanced (L+R)

SPK (L+R) + 4mm binding posts (L+R)

20Hz - 20kHz (±0.5dB)

<0.05%

300

100dB

20V/us

10k Ohms unbalanced, 20k Ohms balanced

Class D

Temperature, short circuit, DC, overload

Power, signal, clip

L+R level, power on/off

482 x 180 x 44mm

3.2kg

PL2000

T15AL (250V)

2 x 540W

2 x 1000W

4.0kg

Errors and omissions excepted.

PL 1400, PL2000 User Manual