Allied Telesis TurboStack AT-TSA2 Panduan Pengguna - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Beralih Allied Telesis TurboStack AT-TSA2. Allied Telesis TurboStack AT-TSA2 18 halaman. At-tsax appliqués

Halaman Cetak

Network Appliqué Options

Optional appliqués are available for connection with ﬁber optic (ST, SC, or SM),

thinnet (BNC) or UTP (RJ45) cabling, in addition to the AUI interface. Figure 3

shows the different appliqué faceplates available.

It is advisable to turn off the power since you will be removing screws and

inserting metal parts into the appliqué slot.

Appliqué Installation/Removal Procedures

Appliqués attach to an TurboStack hub on the front panel. Speciﬁc installation

procedures are described below.

To remove an AUI appliqué

1. Snap off the plastic cover plate on the AUI connector.

2. Remove the AUI appliqué screws and pop it out, as shown in Figure 4.

Do not unscrew the AUI slide kit screws that secure the AUI connector to the

appliqué until the appliqué pops out. The washers and nuts on the back of the slide

kit may fall iniside the hub module and will be difficult to retrieve.

Figure 3: AT-TSAx Appliqués

Note