Avsl Qtx PAL8 Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem mikrofon Avsl Qtx PAL8. Avsl Qtx PAL8 9 halaman.

Bluetooth

Connection



On the media player, select '

' using the MODE button.

Scan for Bluetooth devices on your smart phone or other Bluetooth enabled audio player and

check for a device called "PAL series". Select this device and opt to connect your Bluetooth

device, which should then state that it is connected to "PAL series" for audio output.

Play audio from your Bluetooth device and check for output through the PAL8 unit.

Ensure that the volume is turned up on the smart phone or other sending device.

If there is no output, check if there is more than one device within range called "PAL series"

In the eventuality that more than one device is called "PAL series", try each device in turn until

the PAL8 is found. Check also that the volume level is turned up on the sending device.

Once audio is playing through the PAL8 from Bluetooth, adjust the MASTER control (12) to the

required volume.

In Bluetooth mode, the , ,  buttons can also remotely control playback from the

sending device.

TWS (True Wireless Stereo) pairing

The Bluetooth receiver in the PAL8 is capable of pairing with another PAL8 unit, so that it plays

just one side of the stereo audio and relays the other side of the audio to the other PAL8 over

Bluetooth. This sets up a pair of PAL8 units as a wireless stereo set, known as True Wireless

Stereo pairing.

To activate this function, pair a smart phone to one of the pair of PAL8 units and press and hold

the button labelled TWS for 3 seconds on each PAL8 unit until an audio prompt confirms the

TWS pairing. Bluetooth playback from the smart phone will now be reproduced by both PAL8

units with one playing the left channel and the other playing the right channel.

Holding the TWS button on either unit for 3 seconds will cancel the TWS function.

Front LED light effects

You may decide to activate the LED light show on your PAL8 unit by pressing and holding the

button labelled "LED SWITCH" for 3 seconds. These LEDs will sequentially switch colours, which

increases in speed when there is sound coming from the speaker. Pressing the "LED SWITCH"

button for 3 seconds again will deactivate the LED light show.

To override music playback when speaking into the microphone, press and hold the button

marked TALKOVER for 3 seconds. When active, this will automatically reduce the music output

volume whenever you speak into the microphone and resume the music volume when the

microphone is silent. Holding TALKOVER again for 3 seconds will deactivate this function.

178.960UK User Manual