Allied Telesis AR441S Catatan Rilis - Halaman 7

Jelajahi secara online atau unduh pdf Catatan Rilis untuk Router Jaringan Allied Telesis AR441S. Allied Telesis AR441S 14 halaman. 54266-02 patch release note
Juga untuk Allied Telesis AR441S: Catatan Rilis (6 halaman)

Halaman Cetak

Patch 54266-02

C613-10417-00 Rev B

PCR: 40417

Module: OSPF

When LS Acks (Link State Advert acks) were received, they were compared

against the transmitted LSA (Link State Advert). If it was the same, the LSA

was removed from the re-transmission list. The algorithm used in this check

has been changed to be compliant with the algorithm specified in section

13.1 of RFC2328, to determine if the LS Ack received is the instance as the

LSA.

PCR: 40428

Module: IP, FILTER

If the value specified for the sport or dport parameter in the add ip filter or

set ip filter commands was 65535, then the IP filter process would

incorrectly interpret that value as meaning "any " port. This issue has been

resolved so that port 65535 is now used for the IP filter when specified.

PCR: 40437

Module: CORE

The tick timer was not initialised correctly, which could cause

firewall sessions to time out prematurely when the system time

reached midnight. This issue has been resolved.

PCR: 40493

Module: DHCP

In certain scenarios when acting as a DHCP server, the switch would send

a DHCP ACK to an invalid MAC address. This issue has been resolved.

PCR: 40498

Module: OSPF

When a virtual link end point is no longer reachable, the virtual interface is

not brought down, and the virtual neighbour is not removed. This issue has

been resolved.

PCR: 40513

Module: PIM6

The RP Candidate address was not displayed correctly when issuing the

"show pim6 rps" command. This issue has been resolved.

PCR: 40610

Module: BRIDGE

When the set bridge port command was executed, the bridge configuration

resulting from the create config or show config dynamic=bridge

commands would be incorrect. This issue has been resolved.

PCR: 40676

Module: ADSL, CORE

The ADSL interface, adsl0, did not appear in the Interface Name Summary

table section of the show interface command output or in the

arInterfaceTable in the Allied Telesyn enterprise MIB. This issue has been

resolved.

Level: 3