Allied Telesis AT-9900 Series Manual Fungsi - Halaman 13
Jelajahi secara online atau unduh pdf Manual Fungsi untuk Router Jaringan Allied Telesis AT-9900 Series. Allied Telesis AT-9900 Series 18 halaman. How to set up pppoe between a linux client and access concentrator
Juga untuk Allied Telesis AT-9900 Series: Cara Mengkonfigurasi (9 halaman), Bagaimana-Cara (8 halaman)
Halaman Cetak
Command output
Profile #1:
IPv4 bytes used ......... 3 of 16
Other-Eth bytes used .... 5 of 16
Device Resource, device #1:
Number of rules used ........ 1
Rule space usage ............ 8
Number of rules per application:
Accel. Card(IPv6) ......... 1
Device rule space limit ... 1024
Profile Usage:
Profile #1:
IPv4 bytes used ......... 0 of 16
Other-Eth bytes used .... 6 of 16
Appendix A: How to use the layer 4 mask in classifiers
This section describes the use of L4 mask in classifiers and gives some examples on L4 masks.
The way that L4 masks work is similar to IP subnet masks. You need to be familiar with the
binary system to set the right mask for your need.
The L4 mask is a 2-byte hexadecimal number, the base-16 number system, which consists of
16 unique symbols: the numbers 0 to 9 and the letters A to F.
For example, if we want to set our UDP destination port to 2000:
2000
2000
The default mask
Applying a L4 mask to an UDP/TCP port allows you to identify the constant and variable
parts of the port number. The constant bits are represented by the 1s in the mask, and the
variable bits are represented by the 0s. Performing a bitwise logical AND operation between
the port number and the L4 mask results in the first port number of the range.
Note:
Let's look at some examples.
Page 13 | AlliedWare™ OS How To Note: Hardware Filters
=
=
=
The logical AND operation compares 2 bits and if they are both "1", then the result
is "1", otherwise, the result is "0".
Appendix A: How to use the layer 4 mask in classifiers
Description
Profile used to match on packets
Number of bytes being used in the profile for matching
IPv4 packets
Number of bytes being used in the profile for matching
non-IPv4 ethernet packets
Resources used by device number 2 - accelerator card
1 default rule in the IPv6 card
One 8-rule block has been allocated in the rule table on
the accelerator card
Splitting the rule allocation out on a per-application basis
1 default IPv6 rule
Total number of rules in the rule table on the accelerator
card
Profile used to match on packets
Number of bytes being used in the profile for matching
IPv4 packets
Number of bytes being used in the profile for matching
non-IPv4 ethernet packets
11111010000 (in binary)
07D0 (in hexadecimal)
FF FF
which is 11111111 11111111 (in binary)