Dell 1555 - Studio - Chainlink Panduan Servis - Halaman 24
Jelajahi secara online atau unduh pdf Panduan Servis untuk Laptop Dell 1555 - Studio - Chainlink. Dell 1555 - Studio - Chainlink 50 halaman.
Juga untuk Dell 1555 - Studio - Chainlink: Panduan Servis (50 halaman)
Halaman Cetak
Back to Contents Page
Hard Drive
Dell Studio™ 1555 Service Manual
Removing the Hard Drive
Replacing the Hard Drive
WARNING:
If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To prevent data loss, turn off your computer (see
remove the hard drive while the computer is on or in the Sleep state.
CAUTION:
Hard drives are extremely fragile. Exercise care when handling the hard drive.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
inside the computer.
NOTE:
Dell does not guarantee compatibility or provide support for hard drives obtained from sources other than Dell.
NOTE:
If you are installing a hard drive from a source other than Dell, you need to install an operating system, drivers, and utilities on the new hard
drive (see the Dell Technology Guide).
Removing the Hard Drive
1. Follow the procedures in
Before You
2. Remove the base cover (see
3. Remove the four screws securing the hard drive assembly to the computer base.
4. Slide the hard drive assembly to the side to disconnect it from the hard drive connector and lift it out of the computer base.
1 hard drive assembly 2 screws (4)
5. Remove the four screws securing the hard drive bracket to the hard drive.
6. Separate the hard drive bracket off the hard drive.
Begin.
Removing the Base
Cover).
Before Working Inside Your
Computer) before removing the hard drive. Do not
Before Working Inside Your
Computer) before working