Dell Inspiron 1090 Panduan Servis - Halaman 23
Jelajahi secara online atau unduh pdf Panduan Servis untuk Laptop Dell Inspiron 1090. Dell Inspiron 1090 47 halaman.
Juga untuk Dell Inspiron 1090: Panduan Servis (47 halaman)
Halaman Cetak
Back to Contents Page
Hard-Drive Assembly
Dell™ Inspiron™ 1090 Service Manual
Removing the Hard-Drive Assembly
Replacing the Hard-Drive Assembly
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
CAUTION:
To prevent data loss, turn off your computer (see
remove the hard drive while the computer is On or in Sleep state.
CAUTION:
Hard drives are extremely fragile. Exercise care when handling the hard drive.
NOTE:
Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.
NOTE:
If you are installing a hard drive from a source other than Dell, you need to install an operating system, drivers, and utilities on the new hard
drive.
Removing the Hard-Drive Assembly
1. Follow the instructions in
Before You
2. Remove the label door (see
3. Remove the keyboard (see
4. Remove the palm-rest assembly (see
5. Remove the battery (see
Removing the
6. Remove the memory module (see
7. Remove the screw that secures the hard-drive assembly to the computer base.
8. Using the pull-tab, slide the hard-drive assembly towards the right to disconnect the hard-drive assembly from the connector on the system board.
9. Lift the hard-drive assembly out of the computer.
1
pull-tab
2
hard-drive assembly
Begin.
Removing the Label
Door).
Removing the
Keyboard).
Removing the Palm-Rest
Battery).
Removing the Memory
Module).
Removing the
Turning Off Your
Computer) before removing the hard-drive assembly. Do not
Assembly).
Battery) before working inside the