Dell Inspiron 1090 Panduan Servis - Halaman 33
Jelajahi secara online atau unduh pdf Panduan Servis untuk Laptop Dell Inspiron 1090. Dell Inspiron 1090 47 halaman.
Juga untuk Dell Inspiron 1090: Panduan Servis (47 halaman)
Halaman Cetak
Back to Contents Page
Memory Module
Dell™ Inspiron™ 1090 Service Manual
Removing the Memory Module
Replacing the Memory Module
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
NOTE:
Memory modules purchased from Dell are covered under your computer warranty.
See "Specifications" in the Setup Guide that shipped with your computer or at support.dell.com/manuals for information on the type of memory supported by
your computer.
Your computer has one internal SODIMM connector.
Removing the Memory Module
1. Follow the instructions in
Before You
2. Remove the label door (see
3. Remove the keyboard (see
4. Remove the palm-rest assembly
5. Remove the battery (see
Removing the
CAUTION:
To help prevent damage to the memory-module connector, do not use tools to spread the memory module securing clips.
6. Use your fingertips to carefully spread apart the securing clips on each end of the memory-module connector until the memory module pops up.
1
memory-module connector 2
3
memory module
7. Remove the memory module from the memory-module connector.
Begin.
Removing the Label
Door).
Removing the
Keyboard).
(Removing the Palm-Rest
Assembly).
Battery).
securing clips (2)
Removing the
Battery) before working inside the