Dell Inspiron 1440 Panduan Servis - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Servis untuk Laptop Dell Inspiron 1440. Dell Inspiron 1440 48 halaman.
Juga untuk Dell Inspiron 1440: Panduan Servis (48 halaman)

Halaman Cetak
Dell Inspiron 1440 Panduan Servis
Back to Contents Page
  Processor Module
Dell™ Inspiron™ 1440 Service Manual 
  Removing the Processor Module
  Replacing the Processor Module
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
 
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as the back panel) on the computer.
 
CAUTION:
To prevent intermittent contact between the ZIF-socket cam screw and the processor when removing or replacing the processor, press
to apply slight pressure to the center of the processor while turning the cam screw.
 
CAUTION:
To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when turning the cam screw.
 
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ 
is not covered by your warranty.
 
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
 Removing the Processor Module
 
1. Follow the procedures in
Before You
 
2. Remove the processor heat sink (see
 
3. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.
1
ZIF socket
2
 
CAUTION:
To ensure maximum cooling for the processor, do not touch the heat transfer areas on the processor thermal-cooling assembly. The
oils in your skin can reduce the heat transfer capability of the thermal pads.
 
CAUTION:
When removing the processor module, pull the module straight up. Be careful not to bend the pins on the processor module.
 
4. Lift the processor module from the ZIF socket.
 Replacing the Processor Module
Begin.
Removing the Processor Heat
ZIF-socket cam screw
Removing the
Sink).
Battery) before working inside the