Avtech IR CAMERA Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kamera IP Avtech IR CAMERA. Avtech IR CAMERA 3 halaman. 960h ultra resolution series

INSTALLATION

1. Use the supplied three screws to attach the bracket to wall. Drill a hole in advance on the proper position of the

wall for the Power and Video Cable to pass through later.

2. Remove the Joint Lock from the bracket by turning it counterclockwise. Then, screw the Joint Lock to the

backside of the camera (turn clockwise).

NOTE: There are two screw holes on the backside of the camera. Please choose the proper one which

best suits your installation environment.

3. Screw the camera with the Joint Lock connected to the bracket. After that, secure the Joint Lock to fix. Then,

pass the Power and Video Cable through the hole drilled in Step 1 to hide it.

Figure 1

CONNECTION

1. DC12V Input Terminal

Connect the power terminal of the camera to a DC 12V regulated power supply.

alarm shop

NOTE: Please use the correct power adaptor, DC12V (regulated), to operate this unit. The power

tolerance of this unit is DC12V ± 10%. Over maximum DC 12V power input will damage this unit.

2. Video Output Connector (VIDEO OUT)

Connect the camera video output to the video input of a DVR with 75Ω coaxial cable.

NOTE: To ensure the camera has sufficient protection against moisture, an extra waterproof measure,

such as by using an insulating tape, must be used to cover the power and video connectors after

connection.

Figure 2

Figure 3