Avtech RMA-FS2-SEN Catatan Instalasi

Jelajahi secara online atau unduh pdf Catatan Instalasi untuk Alat Ukur Avtech RMA-FS2-SEN. Avtech RMA-FS2-SEN 4 halaman. Flood sensor spot

AVTECH's Flood Sensor (Spot) monitors

the presence/absence of liquid on a flat

surface. When liquid collects underneath

the blue housing, it bridges the 2 adjustable-

height contacts and trips the sensor. The

contacts, which are 1" apart, arrive 1/32"

off the ground, and adjust individually from

0" to 1/8" high. Self-adhesive feet on the

bottom of the housing allow you to fasten

the sensor to trouble-spots and also provide

a gap to admit water to the contacts.

Housing

Flood Sensor (Spot) Package Contents

• One (1) Flood Sensor with 25' low-voltage 2-wire cable attached

• One (1) 9V alkaline battery

• One (1) Installation Note (You're reading it now.)

Install Your Flood Sensor (Spot)

Do not use this sensor in hazardous (classified) locations or life safety applications.

Step 1: Adjust the height of the contacts if necessary.

You may leave the contacts at the factory-adjusted height of 1/32" away from the

floor, or adjust them between 0" and 1/8" high. To simulate the distance to the

floor, rest a straight-edge on the feet closest to the contacts while you adjust them.

• Tighten the contacts clockwise to raise them further away from the floor.

• Loosen the contacts counter-clockwise to lower them closer to the floor.

While you may lower the contacts flush to the floor (0" high), doing so increases

the chance of a false alarm—mere dampness or a film of dirt could bridge the

contacts. Metal, too, forms a complete circuit, so if you place the unit on a metal

surface, be sure to maintain a gap under the contacts.

AVTECH Software, Inc.

Flood Sensor (Spot) (RMA-FS2-SEN)

Contacts

Liquid

Foot

Temperature & Environment Monitoring ...Made Easy!

0" to 1/8" from Surface

Foot

Installation Note

Surface

AVTECH.com