Dell Studio XPS 13 - Laptop - Obsidian Panduan Servis - Halaman 33

Jelajahi secara online atau unduh pdf Panduan Servis untuk Laptop Dell Studio XPS 13 - Laptop - Obsidian. Dell Studio XPS 13 - Laptop - Obsidian 41 halaman.

Halaman Cetak
WARNING:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
NOTE:
Your computer's Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup program
after you replace the system board.
NOTE:
Replacing the system board removes any changes you have made to the BIOS using the BIOS setup program. You must
make the appropriate changes again after you replace the system board.
Topics:
•

Procedure

•

Post-requisites

•

Entering the Service Tag in the BIOS setup program

Procedure
1
Slide the system board under the tabs on the palm-rest assembly and align the screw holes on the system board with the screw holes
on the palm-rest assembly.
2
Replace the seven screws (M1.6x2.5) that secure the system board to the palm-rest assembly.
3
Replace the screw (M1.6x3) that secures the system board to the palm-rest assembly.
4
Slide the power-button cable, fingerprint-reader cable, battery-status light cable, the touch-pad cable, the keyboard-backlight cable,
and the keyboard-controls board cable into the system board and close the latches to secure the cables.
5
Connect the camera cable, the touch-screen cable, the coin-cell battery cable, the speaker cable, and the display cable to the system
board.
6
Adhere the tape that secure the speaker cable to the system board.
7
Align the screw holes on the display-cable bracket with the screw holes on the system board.
8
Replace the two screws (M1.6x2.5) that secure the display-cable bracket to the system board.
Post-requisites
1
Reconnect the
wireless
card.
2
Replace the
solid-state
drive.
3
Replace the battery.
4
Replace the
base
cover.
Entering the Service Tag in the BIOS setup program
1
Turn on or restart your computer.
2
Press F2 when the Dell logo is displayed to enter the BIOS setup program.
3
Navigate to the Main tab and enter the Service Tag in the Service Tag Input field.
NOTE:
Service tag is the alphanumeric identifier located at the back side of your computer.

Replacing the system board

computer. After working inside your computer, follow the instructions in
20
After working inside
www.dell.com/
Replacing the system board
33