Dell Studio XPS 1640 Panduan Servis - Halaman 33
Jelajahi secara online atau unduh pdf Panduan Servis untuk Laptop Dell Studio XPS 1640. Dell Studio XPS 1640 49 halaman.
Halaman Cetak
Back to Contents Page
Wireless Mini-Card
Dell™ Studio XPS™ 1640 Service Manual
Removing the Mini-Card
Replacing the Mini-Card
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not
covered by your warranty.
NOTICE:
To help prevent damage to the system board, remove the main battery (see
computer.
NOTE:
Dell does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell.
If you ordered a wireless Mini-Card with your computer, the card is already installed.
Your computer has three Mini-Card slots:
two Full Mini-Card slots
l
one Half Mini-Card slot
l
The types of Mini-Cards supported are:
Wireless Local Area Network (WLAN) — Half Mini-Card
l
Mobile broadband or Wireless Wide Area Network (WWAN) — Full Mini-Card
l
Wireless Personal Area Network (WPAN) or Internal Card with Bluetooth® Wireless Technology — Full Mini-Card
l
NOTE:
Your computer can only support two Full Mini-Cards and one Half Mini-Card at a time.
NOTE:
The WLAN slot supports a half Mini-Card.
NOTE:
Depending on the configuration of the system when it was sold, one or more of the Mini-Card slots may not have Mini-Cards installed in them.
Removing the Mini-Card
1. Follow the instructions in
Before You
2. Remove the base cover (see
3. Disconnect the antenna cables from the Mini-Card.
NOTE:
If you are removing a WPAN Mini-Card, disconnect the blue antenna cable from the Mini-Card.
1
Mini-Card
2
screw
4. Remove the screw that secures the Mini-Card to the system board.
Begin.
Removing the Base
Cover).
3
antenna cable connectors (2)
Before Working Inside Your
Computer) before working inside the