Dell Vostro 5390 Manual Pengaturan dan Spesifikasi - Halaman 26
Jelajahi secara online atau unduh pdf Manual Pengaturan dan Spesifikasi untuk Laptop Dell Vostro 5390. Dell Vostro 5390 35 halaman.
Juga untuk Dell Vostro 5390: Manual Pengaturan dan Spesifikasi (36 halaman)
Halaman Cetak
Video
Option
Description
LCD Brightness
Allows you to set the display brightness depending up on the power source—On Battery and On AC. The
LCD brightness is independent for battery and AC adapter. It can be set using the slider.
NOTE:
The video setting is visible only when a video card is installed into the system.
Security
Table 30. Security
Option
Admin Password
System Password
Strong Password
Password Configuration
Password Bypass
Password Change
Non-Admin Setup Changes
UEFI Capsule Firmware
Updates
TPM 2.0 Security
26
BIOS setup
Description
Allows you to set, change, and delete the admin password.
Allows you to set, change, and delete the system password.
This option lets you enable or disable strong passwords for the system.
Allows you to control the minimum and maximum number of characters allowed for a
administrative password and the system password. The range of characters is between 4
and 32.
This option lets you bypass the System (Boot) Password and the internal HDD password
prompts during a system restart.
● Disabled — Always prompt for the system and internal HDD password when they are set.
This option is enabled by default.
● Reboot Bypass — Bypass the password prompts on Restarts (warm boots).
NOTE:
The system will always prompt for the system and internal HDD passwords when
powered on from the off state (a cold boot). Also, the system will always prompt for
passwords on any module bay HDDs that may be present.
This option lets you determine whether changes to the System and Hard Disk passwords are
permitted when an administrator password is set.
Allow Non-Admin Password Changes - This option is enabled by default.
Determines whether changes to the setup option are permitted when an administrator
password is set.
This option controls whether this system allows BIOS updates via UEFI capsule update
packages. This option is selected by default. Disabling this option will block BIOS updates
from services such as Microsoft Windows Update and Linux Vendor Firmware Service
(LVFS)
Allows you to control whether the Trusted Platform Module (TPM) is visible to the operating
system.
● TPM On (default)
● Clear
● PPI Bypass for Enable Commands
● PPI Bypass for Disable Commands
● PPI Bypass for Clear Commands
● Attestation Enable (default)
● Key Storage Enable (default)
● SHA-256 (default)
Choose any one option:
● Disabled
● Enabled (default)