Dell XFR630 Panduan Referensi Cepat - Halaman 22

Jelajahi secara online atau unduh pdf Panduan Referensi Cepat untuk Laptop Dell XFR630. Dell XFR630 23 halaman. With touch fully rugged notebook

Halaman Cetak

2. Press and hold the <Fn> key while powering the computer on.

NOTE: If you see a message stating that no diagnostics utility partition has been found, run the

Dell Diagnostics from the optional Drivers and Utilities CD.

The computer runs the Pre-boot System Assessment (PSA), a series of initial tests of your system board,

keyboard, hard drive, and display.

During the assessment, answer any questions that appear.

If a failure is detected, the computer stops and beeps. To stop the assessment and restart the

computer, press <N>; to continue to the next test, press <Y>; to retest the component that failed,

press <R>.

If failures are detected during the Pre-boot System Assessment, write down the error code(s) and

contact Dell.

If the Pre-boot System Assessment completes successfully, the following message appears: "Booting Dell

Diagnostic Utility Partition. Press any key to continue".

4. Press any key to start the Dell Diagnostics from the diagnostics utility partition on your hard drive.

6.2.3

Starting the Dell Diagnostics From the Drivers and Utilities

1. Insert the Drivers and Utilities CD.

2. Shut down and restart the computer.

When the DELL logo appears, press <F12> immediately.

NOTE: If you wait too long and the operating system logo appears, continue to wait until you

see the Microsoft

NOTE: The next steps change the boot sequence for one time only. On the next start-up, the

computer boots according to the devices specified in the system setup program.

3. When the boot device list appears, highlight CD/DVD/CD-RW Drive and press <Enter>.

4. Select the Boot from CD-ROM option from the menu that appears and press <Enter>.

5. Type 1 to start the CD menu and press <Enter> to proceed.

6. Select "Run the 32 Bit Dell Diagnostics" from the numbered list. If multiple versions are listed, select the

version appropriate for your computer.

7. When the Dell Diagnostics Main Menu appears, select the test you want to run.

6.2.4

Dell Diagnostics Main Menu

1. After the Dell Diagnostics loads and the Main Menu screen appears, click the button for the option you want.

NOTE: It is recommended that you select Test System to run a complete test on your

computer.

Option

Test Memory

Test System

Exit

2. After you have selected the Test System option from the main menu the following menu appears:

NOTE: It is recommended that you select Extended Test from the menu below to run a more

thorough check of the devices in your computer.

Option

Express Test

Windows

desktop; then shut down your computer and try again.

Function

Run the stand-alone memory test

Run the System Diagnostics

Exit the Diagnostics

Function

Performs a quick test of devices in the system. This typically can