Dell XPS M1210 Panduan Servis - Halaman 36

Jelajahi secara online atau unduh pdf Panduan Servis untuk Laptop Dell XPS M1210. Dell XPS M1210 45 halaman.

Back to Contents Page

Palm Rest

Dell™ XPS™ M1210 Service Manual

Removing the Palm Rest

Replacing the Palm Rest

Removing the Palm Rest

CAUTION:

Before you begin the following procedure, follow the safety instructions in the Product Information Guide.

NOTICE:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such

as the back panel) on the computer.

NOTICE:

To help prevent damage to the system board, remove the main battery (see

computer.

1. Follow the instructions in

Before Working Inside Your

2. Remove the M2 x 3-mm screw from the internal card with Bluetooth® wireless technology (if installed).

3. Remove the optical drive (see

4. Remove the hinge cover (see

5. Remove the keyboard (see Keyboard).

6. Remove the display assembly (see

7. Remove the seven M2.5 x 5-mm screws labeled "P" from the top side of the palm rest.

NOTE:

The screw locations may vary slightly from the image shown.

M2.5 x 5-mm screws (7)

8. Disconnect the coin-cell battery cable from the system board.

9. Disconnect the touch-pad connector from the system board.

NOTE:

If you are unable to reach the touch-pad connector with the palm rest in place, you may want to wait until

palm rest enough to reach under it and access the touch-pad connector.

10. Turn the computer upside down, loosen the captive screw, and remove the four M2.5 x 8-mm screws from the bottom of the computer.

Computer.

Optical

Drive).

Removing the Hinge

Cover).

Removing the Display

Assembly).

touch-pad connector

Before Working Inside Your

Computer) before working inside the

step 11

when you can raise the