Dell 540s - Studio Slim Desktop Pc Panduan Servis - Halaman 27
Jelajahi secara online atau unduh pdf Panduan Servis untuk Desktop Dell 540s - Studio Slim Desktop Pc. Dell 540s - Studio Slim Desktop Pc 38 halaman. Service manual
Halaman CetakBack to Contents Page
Replacing the Power Supply
Dell Studio™ Slim 540s Service Manual
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To guard against likelihood of electric shock, laceration by moving fan blades or other unexpected injuries, always unplug your
computer from the electrical outlet before removing the cover.
NOTICE:
Do not perform the following steps unless you are familiar with hardware removal and replacement. Performing these steps incorrectly could
damage your computer. To contact Dell for technical assistance, see the Setup Guide.
1. Follow the procedures in
Before You
2. Remove the computer cover (see
NOTICE:
Note the location and ID of each power connector before disconnecting the power supply cables.
3. Follow the DC power cables that stem from the power supply and disconnect each connected power cable.
NOTE:
Note the routing of the DC power cables underneath the tabs in the computer chassis as you remove them from the system board and
drives. You must route these cables properly when you replace them to prevent them from being pinched or crimped.
4. Remove the three screws that secure the power supply to the back of the computer chassis.
1 screws (3) 2 power supply
5. Slide the power supply towards the front of the computer and lift it out.
6. Slide the replacement power supply towards the back of the computer.
CAUTION:
Failure to replace and tighten all screws may cause electrical shock as these screws are a key part of the system grounding.
7. Replace the three screws that secure the power supply to the back of the computer chassis.
NOTICE:
Route the DC power cables under the chassis tabs. The cables must be properly routed to prevent the cables from being damaged.
8. Reconnect the DC power cables to the system board and drives.
NOTE:
Check all cable connections to make sure they are secure.
9. Replace the computer cover (see
Begin.
Replacing the Computer
Cover).
Replacing the Computer
Cover).