DH electronics 96Boards Avenger96 Memulai - Halaman 11

Jelajahi secara online atau unduh pdf Memulai untuk Perangkat Keras Komputer DH electronics 96Boards Avenger96. DH electronics 96Boards Avenger96 19 halaman.
Juga untuk DH electronics 96Boards Avenger96: Memulai (14 halaman)

Halaman Cetak
Avenger96 – Getting Started

1.1.7 JTAG-Connectors

As a standard the JTAG-connector X12 is not populated on the Avenger96, but in case JTAG is needed, there are
two ways to connect to it:
Tag-Connect (X13 and X14):
The Avenger96 has a standard Tag-Connect TC2050 footprint. With this design JTAG can be accessed with a
standardized TC2050-IDC-NL-Cable. In order to hold the cable in place, there is also an TC2050-CLIP available,
which locks the cable to the board.
The Tag-Connect footprint is placed on the top side of the Avenger96 as well as on the bottom side. This way the
connector can be used on either side of the board.
Pin
10
R03
1
2
3
4
5
6
7
8
9
DOC_Getting-Started-588-200.docx
Net
+1V8
SYS_JTMS-SWDIO
GND
SYS_JTCK-SWCLK
GND
SYS_JTDO-SWO
SYS_JTRST
SYS_JTDI
Not Connected
Not Connected
DH electronics GmbH
Page 11 / 19