Dell Dimension 4700C Panduan Servis - Halaman 24

Jelajahi secara online atau unduh pdf Panduan Servis untuk Desktop Dell Dimension 4700C. Dell Dimension 4700C 42 halaman. Dell desktop computer quick setup guide
Juga untuk Dell Dimension 4700C: Panduan Pengaturan Cepat (2 halaman)

Halaman Cetak
Dell Dimension 4700C Panduan Servis
 
13. Place the system board that you just removed next to the replacement system board.
 

Replacing the System Board

 
1. Transfer components from the existing system board to the replacement system board:
a.
 Remove the memory modules
 
CAUTION:
The heat-sink assembly and processor package can get hot. To avoid burns, ensure that the assembly and package have had sufficient
time to cool before you touch them.
b.
 Remove the heat-sink assembly and processor package
c.
 Remove the modem
 
2. Configure the settings of the replacement system board.
 
3.
Set the jumpers
on the replacement system board so that they are identical to the ones on the existing system board.
NOTE:
Some components and connectors on the replacement system board may be in different locations from corresponding connectors on the existing
system board.
 
4. Orient the replacement system board by aligning the slots in the bottom of the board to the tabs on the computer.
 
5. Slide the system board down onto the pins.
 
6. Replace the screw that holds the system board down.
 
7. Reconnect the modem cable and ground wire to the modem:
a.  Reconnect the modem cable from the modem.
b.  Use a size #1 screwdriver to remove the screws securing the modem and ground wire to the system board, and set the screws aside.
 
8. Replace any components and cables that you removed from the system board.
 
9. Reconnect all cables to their connectors at the back of the computer.
 
10.
Close the computer
cover.
 
11.
Attach the computer stand
(optional).
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
 
12. Connect your computer and devices to electrical outlets, and turn them on.
and install them on the replacement system board.
from the existing system board and transfer it to the replacement system board.
from the existing system board and transfer them to the replacement system board.