Cradlepoint AER1600LPE Panduan Memulai Cepat - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Router Nirkabel Cradlepoint AER1600LPE. Cradlepoint AER1600LPE 6 halaman. Micro branch router
Halaman Cetak
11/2/2020
Read through the following to set up your AER1600 Series Micro Branch Router.
STEP 1: Check box contents.
The AER1600 Series router includes the following:
An AER1600 Series Router
An MC400 LTE Modem*
A 12V 3A AC/DC Power Adapter
Modem Antennas (quantities vary by model)
An Ethernet Cable
A Safety, Regulatory, and Warranty Guide
*Included with AER1600LP3 and AER1650LP3. Optional for AER1600, AER1650, AER1600LPE, and AER1650LPE.
STEP 2: Insert an activated SIM.
If setting up cellular connectivity, do the following:
1. Turn the router over and remove the screw to the SIM door.
2. Lift the SIM 1 card slot and insert an activated 2FF-sized SIM card. Insert the card with the metal contacts facing the interior of the device when closed
and notch end up. Refer to the image above.
3. Insert a second activated SIM card into the SIM 2 card slot, if desired.
4. Flip the SIM slot(s) down then close and secure the SIM door with the screw.
STEP 3 (Optional): Insert a modular MC400 modem.
The AER1600 Series has a slot for a removable modular MC400. If using the optional additional MC400 modem, it must be installed before the AER1600
Series router can be set up. To install this modem, do the following:
1. Insert an activated 2FF-sized SIM card into the MC400 modem, metal contacts down, notch end first.
2. Remove the modem door on the AER1600 Series device.
3. Slide the MC400 modem into the available modem into the available modem slot, USB plug first, with the Cradlepoint logo facing up.
4. Replace the MC400 modem door cover. NOTE: Remove the plastic SMA covers from the modem door cover fo the additional antenna ports on the
modem.
5. Secure the door cover screw (beneath the device). NOTE: The modem door cover must be on the router or the embedded modem will not power on.
STEP 4: Attach the antennas.
Attach the included Wi-Fi antennas to the connectors.
1. Hold the antenna straight and twist the base onto the SMA port on the device.
Do not over-tighten. The maximum recommended torque is 4 in-lbs.
2. Bend each antenna at the joint for optimal signal reception.
https://customer.cradlepoint.com/s/article/AER1600-Series-Micro-Branch-Networking-Router
AER1600 Series Micro Branch Router Quick Start Guide
3/6