2Wire i38HG Panduan Pengguna - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Modem 2Wire i38HG. 2Wire i38HG 20 halaman.

Connecting via Wireless

Your i38HG has an integrated wireless access point (AP) that enables you to connect your wireless-enabled

computers to your home network. By default, the i38HG is shipped with WPA-PSK and WPA2-PSK enabled

and a preconfigured network name. Refer to the

wireless network.

You can connect up to eight i38HGs (that is, APs) in your home. When multiple APs are detected, they are

automatically synchronized across all managed access points to create a single wireless network for easier

device connectivity. The default service set identifier (SSID) and wireless key is based on the last three

digits of the serial number on the first access point that was connected. If you have multiple APs installed,

refer to the label on your first installed AP only. All subsequent access points are automatically

synchronized with the default SSID or with any custom SSID you define subsequent to initial installation.

Most laptop computers are equipped with an internal 802.11b/g card. If your computer is not equipped

with an internal card, you can install an external wireless adapter for wireless networking. The 2Wire

wireless adapter provides a 2Wire Setup Wizard that automatically configures it to communicate with the

i38HG during setup. If you are using a non-2Wire wireless adapter, you must manually configure it to

communicate with the i38HG. Refer to the

wireless network adapter.

If you are using a non-2Wire wireless adapter, you must manually configure it to communicate with the

i38HG. This section provides instructions to configure your adapter with WPA. You can use WEP if your

wireless adapter does not support WPA; however, this decreases the level of security provided for wireless

traffic.

Install and configure your wireless adapter according to the manufacturer's instructions.

Use the network adapter configuration software or Windows network connection wizard to set the

network name (SSID) and encryption key (WPA).

Enter

(in capital letters) as the network name, followed by the last three digits of the i38HG

2WIRE

serial number (for example, 2WIRE110), located on the bottom of your i38HG

Note:

If you have multiple APs, use the last three digits of the first i38HG

connected to the network.

Configuring Wireless Network

Configuring non-2Wire Wireless Adapters

Installing Your i38HG

section to configure your

section to install a

(Figure

7).