Allied Telesis AR400 Series Bagaimana-Cara - Halaman 2

Jelajahi secara online atau unduh pdf Bagaimana-Cara untuk Perangkat lunak Allied Telesis AR400 Series. Allied Telesis AR400 Series 8 halaman. How to set up pppoe between a linux client and access concentrator
Juga untuk Allied Telesis AR400 Series: Cara Mengkonfigurasi (6 halaman), Panduan Pemecahan Masalah (8 halaman), Pemecahan masalah (5 halaman), Panduan Pemasangan Cepat (8 halaman), Panduan Pemasangan Cepat (12 halaman), Manual Informasi Keselamatan (18 halaman)

Configuring your Allied Telesis Device

Before starting, ensure that your PC has a version of rp-pppoe.

If rp-pppoe isn't on your PC, do one of the following;

•

Download it from

compile and install it.

•

Use the prepackaged installer, for example RPM or deb.

add user=linux_client pass=password

set user=linux_client telnet=no ipaddr=192.168.0.1

# PPP templates configuration

create ppp template=1

set ppp template=1 bap=off authentication=chap

# PPP configuration

add ppp acservice=test template=1 vlan=1

ena ppp accessconcentrator

# IP configuration

enable ip

add ip int=vlan1 ip=192.168.0.254

Network diagram

Linux PC (client)

Set Up PPPoE Between a Linux Client and an Allied Telesis Access Concentrator

http://www.roaringpenguin.com/penguin/open_source_rp-pppoe.php

Configure your Allied Telesis device as follows:

netmask=255.255.255.255

eth 1

port 1

Allied Telesis switch

(Access Concentrator)

, then