Allied Telesis AR440S Catatan Rilis - Halaman 3

Jelajahi secara online atau unduh pdf Catatan Rilis untuk Perangkat lunak Allied Telesis AR440S. Allied Telesis AR440S 14 halaman. 54266-02 patch release note

Halaman Cetak

Patch 54266-02

C613-10417-00 Rev B

PCR: 40419

Module: OSPF, IPG

If OSPF was configured using the command set ospf dyninterface=stub, to

advertise dynamic interfaces such as PPPoE interfaces as stub links, the

links were not being advertised as expected. This issue has been resolved.

PCR: 40442

Module: IPSEC

When an IPSEC policy is used on a PPP link with iprequest=on, when the

PPP link goes down and IPSEC has traffic to transmit, IPSEC repeatedly

attempts to activate the PPP link again. The frequency of the reactivation

attempts has been reduced.

PCR: 40446

Module: DHCP

In certain situations, if a DHCP client used a DHCP relay agent to request

IP addresses from the router acting as the DHCP server on a different

subnet, it was not be able to renew the IP address allocated to it. This issue

has been resolved.

PCR: 40450

Module: IPG

IGMP entries were sometimes changed to static entries rather than being

deleted when IGMP leaves were received. This issue has been resolved.

PCR: 40451

Module: FIREWALL

The "number of hits" counter in firewall's application rules was not

incremented correctly. This issue has been resolved.

PCR: 40453

Module: PIM

Particular IP packets (unicast destination IP, but multicast destination MAC)

could result in a memory leak, which in some cases could cause the device to

stop responding to the command line. This issue has been resolved.

PCR: 40456

Module: IPG

The enable switch learning command would fail if 802.1X port

authentication was enabled on any of the switch ports. This issue has been

resolved.

PCR: 40458

Module: IPG

The router was accepting network RIP packets from foreign subnets. This

issue has been resolved.

PCR: 40465

Module: PIM6, PIM4

The router could reboot when a user changed the Rendezvous Point

Candidate (RPC) priority in the PIM6 module. This issue has been resolved.

Level: 2