Dell Wyse Z90S7 Panduan Instalasi - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Desktop Dell Wyse Z90S7. Dell Wyse Z90S7 24 halaman. Z class cloud clients
Juga untuk Dell Wyse Z90S7: Panduan Instalasi (18 halaman), Panduan Memulai Cepat (6 halaman), Panduan Memulai Cepat (8 halaman), Panduan Memulai Cepat (8 halaman), Panduan Memulai Cepat (8 halaman), Panduan Memulai Cepat (6 halaman), Panduan Memulai Cepat (6 halaman), Panduan Memulai Cepat (8 halaman), Panduan Memulai Cepat (6 halaman), Panduan Memulai Cepat (6 halaman)

Installing Z Class Flash

7. Remove the existing flash module. Locate the flash module and use the Phillips

Screwdriver to remove its retaining screw as shown in Figure 11. Lift the flash

module out of the socket.

Figure 11 Removing the existing flash module

8. Install the new flash module in the reverse order of removing the original flash

module. Carefully screw down its retaining screw until it is secure.

9. (a) Align the cover screw tabs with screw holes and press downward; (b) slide cover

toward the front of the thin client, as shown in Figure 12.

Figure 12 Reattaching the cover

10., Attach the screws in the reverse order as described in step 3.

11. Connect the power cord and power adapter, attach any other cables to the thin

client, and then attach the vertical foot.

CAUTION: Do not turn on the thin client. The thin client is ready to re-image,

however the flash module does not contain an operating system. Turning on power

to your thin client without firmware will display the error message "NO OPERATING

SYSTEM FOUND."

12.Continue with "Installing Firmware."