Dell Active Fabric Manager Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Server Dell Active Fabric Manager. Dell Active Fabric Manager 44 halaman. Active fabric manager installation guide 1.5
Juga untuk Dell Active Fabric Manager: Panduan Instalasi (19 halaman)

Halaman Cetak

Configure Active Fabric Manager as a Virtual

Appliance

Starting with Release 1.5 of Active Fabric Manager (AFM), you can deploy the AFM as virtual appliance on a VMware®

ESX® virtual machine or Workstation™. In this guide, you learn how to configure the AFM as a virtual appliance. The

instructions in this document assume you have already installed and configured an ESX host or workstation where you

plan to run AFM. For additional information about installing and configuring the ESX virtual host machine or Workstation,

consult the VMware documentation.

To configure AFM as a virtual appliance:

Review the Prerequisites

Deploy the OVF Template

Start the AFM VM

Manage the AFM Virtual Appliance

Perform Initial Configuration

Prerequisites

NOTE: If you are using the AFM VM as a syslog and a TFTP or FTP server, you do not need to gather the following

information.

Before you begin, gather the following information:

•

Syslog IP addresses — IP address of remote syslog server.

•

TFTP or FTP server address — IP address of TFTP or FTP server for the Dell Networking Operating System

(FTOS) software images and configuration files during bare metal provisioning (BMP). If you are using an FTP

server, obtain the user name and password.

Hardware Requirements

Disk Space

1TB 7.2K RPM SATA 3.5 Hot Plug Hard Drive

System Type

64-bit operating system

Processor

Intel® Xeon® E5620 2.4Ghz, 12M Cache,Turbo, HT, 1066MHz Max Memory

Memory

32GB Memory (8x4GB), 1333MHz Dual Ranked LV RDIMMs for 2 Processors, Advanced ECC

Virtual Appliance Requirements

AFM runs as a virtual appliance. It requires the following software to host the solution:

•

VMware® Workstation™ version 8.0.5 and higher