Dell DX6000 Panduan Memulai - Halaman 25

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Server Dell DX6000. Dell DX6000 28 halaman. Rack installation instructions — static rails
Juga untuk Dell DX6000: Panduan Tambahan (4 halaman), Petunjuk Pemasangan Perangkat Keras (2 halaman), Panduan Pengguna (46 halaman), Panduan Penyiapan dan Konfigurasi (43 halaman), Panduan Instalasi dan Konfigurasi (35 halaman), Pemberitahuan (28 halaman), Pemberitahuan (20 halaman), Ikhtisar (19 halaman), Panduan Konfigurasi (9 halaman), Panduan Konfigurasi (9 halaman), Catatan Rilis (8 halaman), Panduan Referensi (12 halaman), Panduan Konfigurasi (7 halaman), Catatan Rilis (6 halaman), Catatan Rilis (5 halaman), Catatan Rilis (5 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Instalasi (2 halaman)

4.2.1. Editing node.cfg

This section discusses how to configure a DX Storage cluster node by manually editing /caringo/

node.cfg.

Note

A failsafe timer mechanism is included in the DX Storage startup process that will restart

the boot process if the boot error screen displays for longer than 15 minutes. This reboot

is intended to compensate for temporary network conditions and will be canceled if an

administrator uses a keyboard on the console. Multiple reboots in a row indicate there

might be a problem with the system configuration, in which case you should check the

syslog server for errors.

To manually edit /caringo/node.cfg using any text editor on the Windows, Mac, or Linux

platforms:

1. Using a text editor, open /caringo/node.cfg on the USB flash drive.

2. Make sure to set the parameter vols = all.

This parameter causes DX Storage to use all available volumes on the node. For more

information, see

3. Set other configuration parameters as desired using the guidelines discussed in the appendix on

node configuration in the DX Object Storage Administration Guide.

4. Make sure a valid license.txt file is located in the /caringo directory.

5. Set the cluster configuration parameter to name of your cluster. Dell strongly recommends you

use an

IANA-compatible domain

To prevent confusion, both in viewing the cluster from the administration console and

downstream in applications like DX Content Router that might analyze the source cluster, Dell

highly recommends that all nodes in the cluster be configured with the same cluster name.

6. Boot the DX Storage node from the configured USB device.

If your node boots from a USB flash drive, make sure to safely unmount or stop the USB flash

drive from the computer after configuration editing has been completed. If the flash drive is simply

unplugged without doing this, the changes might not be saved to the node.cfg file.

DX Storage reads the vols parameter from the node and/or cluster configuration files to determine

which disks may be used for content storage. As shipped, DX Storage has a dummy value that

prevents unexpected formatting of a node's disks. An administrator must edit the vols parameter

and replace the dummy value with the keyword all or with a list of disks that DX Storage can use

for storage.

The easiest way to use all disks for content storage in a DX Storage node is to set the vols

parameter as follows:

vols = all

Section 4.2.2, "Storage Volume Configuration"

name, such as cluster.example.com.

Version 5.0

December 2010