Dell EMC PowerEdge C6420 Panduan Referensi - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Referensi untuk Server Dell EMC PowerEdge C6420. Dell EMC PowerEdge C6420 26 halaman.
Halaman Cetak
Boot Settings
You can use the Boot Settings screen to set the boot mode to either BIOS or UEFI. It also enables you to specify the boot
order.
● UEFI: The Unified Extensible Firmware Interface (UEFI) is a new interface between operating systems and platform
firmware. The interface consists of data tables with platform related information, boot and runtime service calls that are
available to the operating system and its loader. The following benefits are available when the Boot Mode is set to UEFI:
○ Support for drive partitions larger than 2 TB.
○ Enhanced security (e.g., UEFI Secure Boot).
○ Faster boot time.
NOTE:
You must use only the UEFI boot mode in order to boot from NVMe drives.
● BIOS: The BIOS Boot Mode is the legacy boot mode. It is maintained for backward compatibility.
Viewing Boot Settings
To view the Boot Settings screen, perform the following steps:
Steps
1. Power on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click Boot Settings.
Boot Settings details
About this task
The Boot Settings screen details are explained as follows:
Option
Description
Boot Mode
Enables you to set the boot mode of the system.
If the operating system supports UEFI, you can set this option to UEFI. Setting this field to BIOS enables
compatibility with non-UEFI operating systems. This option is set to UEFI by default.
Boot Sequence
Enables or disables the Boot Sequence Retry feature. If this option is set to Enabled and the system
Retry
fails to boot, the system re-attempts the boot sequence after 30 seconds. This option is set to Enabled
by default.
Hard-Disk
Specifies the drive that is booted in the event of a drive failure. The devices are selected in the Hard-
Failover
Disk Drive Sequence on the Boot Option Setting menu. When this option is set to Disabled, only the
first drive in the list is attempted to boot. When this option is set to Enabled, all drives are attempted to
boot in the order selected in the Hard-Disk Drive Sequence. This option is not enabled for UEFI Boot
Mode. This option is set to Disabled by default.
Generic USB
Enables or disables the USB boot option. This option is set to Disabled by default.
Boot
12
Pre-operating system management applications
CAUTION:
Switching the boot mode may prevent the system from booting if the operating
system is not installed in the same boot mode.
NOTE:
Setting this field to UEFI disables the BIOS Boot Settings menu.