Dell EMC PowerEdge R550 Panduan Referensi - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Referensi untuk Server Dell EMC PowerEdge R550. Dell EMC PowerEdge R550 25 halaman.

Halaman Cetak

NOTE:

Operating systems must be UEFI-compatible to be installed from the UEFI boot mode. DOS and 32-bit operating

systems do not support UEFI and can only be installed from the BIOS boot mode.

NOTE:

For the latest information about supported operating systems, go to www.dell.com/ossupport.

Changing boot order

About this task

You may have to change the boot order if you want to boot from a USB key or an optical drive. The following instructions may

vary if you have selected BIOS for Boot Mode.

NOTE:

Changing the drive boot sequence is only supported in BIOS boot mode.

Steps

1. On the System Setup Main Menu screen, click System BIOS > Boot Settings > UEFI Boot Settings > UEFI Boot

Sequence.

2. Use the arrow keys to select a boot device, and use the plus (+) and minus (-) sign keys to move the device down or up in

the order.

3. Click Exit, and then click Yes to save the settings on exit.

NOTE:

You can also enable or disable boot order devices as needed.

Network Settings

To view the Network Settings screen, power on the system, press F2, and click System Setup Main Menu > System BIOS

> Network Settings.

NOTE:

Network Settings are not supported in BIOS boot mode.

Table 12. Network Settings details

Option

UEFI PXE Settings

PXE Device n (n = 1 to 4)

PXE Device n Settings(n = 1 to 4)

UEFI HTTP Settings

HTTP Device n (n = 1 to 4)

HTTP Device n Settings (n = 1 to 4)

UEFI iSCSI Settings

Table 13. PXE Device n Settings details

Option

Interface

Protocol

Vlan

Vlan ID

Vlan Priority

Description

Enables you to control the configuration of the UEFI PXE device.

Enables or disables the device. When enabled, a UEFI PXE boot option is

created for the device.

Enables you to control the configuration of the PXE device.

Enables you to control the configuration of the UEFI HTTP device.

Enables or disables the device. When enabled, a UEFI HTTP boot option is

created for the device.

Enables you to control the configuration of the HTTP device.

Enables you to control the configuration of the iSCSI device.

Description

Specifies NIC interface used for the PXE device.

Specifies Protocol used for PXE device. This option is set to IPv4 or IPv6. This option is set to

IPv4 by default.

Enables Vlan for PXE device. This option is set to Enable or Disable. This option is set to

Disable by default.

Shows the Vlan ID for the PXE device

Shows the Vlan Priority for the PXE device.

Pre-operating system management applications