Dell Force10 S2410 Panduan Memulai Cepat - Halaman 24

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Server Dell Force10 S2410. Dell Force10 S2410 31 halaman. Installing the s2410 system
Juga untuk Dell Force10 S2410: Manual (42 halaman)

Halaman Cetak

Setting the IP Address of the Virtual

Management Port

If you want to access the switch through Telnet, SSH, TFTP, or the SFTOS Web

UI, you must set up the service port to configure an IP address that is accessible,

by default, through ports in VLAN 1. You can also do both with separate IP

addresses.

Step Task

Set the IP gateway of the

management interface.

Invoke the (Config-if-ma)#

prompt.

Set the IP address and subnet

mask of the management

interface.

Verify management IP

configuration.

NOTE: By default, the virtual management IP address is reachable from VLAN 1

and all physical ports are members of VLAN 1. So the management IP address will

be reachable from all enabled physical ports by default.

Creating a Simple Configuration using

VLANs and STP

NOTE: As noted in Enabling Ports, all ports are disabled by default. Enable them

with the no shutdown all command (Global Config mode), or individually with the

no shutdown command. The equivalent action on the Web UI is to select Enable

in the Admin mode field on the Port Configuration panel.

Use the line interface command to create a VLAN and then add a tagged

interface and an untagged interface to it.

Installing the Software

Command Syntax

management route default

gateway

interface

managementethernet

ip address ipaddr

subnetmask

show interface

managementethernet

Command Mode

Global Config

(Config-if-ma)#

prompt

User Exec or

Privileged Exec