Dell PowerApp 120 Panduan Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Server Dell PowerApp 120. Dell PowerApp 120 6 halaman. Systems information update
Juga untuk Dell PowerApp 120: Panduan Instalasi (3 halaman), Pembaruan Informasi (12 halaman)

Halaman Cetak

support.dell.com

Five-Volt Riser Board Installation

Dell now offers a Peripheral Component Interconnect (PCI) riser board for use with

customer-furnished five-volt (5V) PCI cards. Dell does not currently support any 5V PCI

cards installed in the Dell™ PowerEdge™ 1550 or PowerApp™ 120 systems. This 5V

riser board is furnished for the customer's convenience.

These systems have one fixed expansion-card connector and one removable riser

board with a single expansion-card connector, which simplifies many installation pro-

cedures by allowing the user to remove the riser board and its installed expansion

card in a single step.

Expansion-Card and Riser-Board Removal

To remove the riser board and its installed expansion card, perform the following

steps.

NOTE: If the system is mounted high in the rack, you may find it easier to completely

remove the system from the rack before performing this procedure.

Shut down the system and turn off power to the system.

Disconnect the power cable from the back of the system chassis.

Loosen the front-panel thumbscrews securing the front panel to the rack and pull

the system chassis out of the top cover to its fully extended position.

Label and disconnect any cables connected to the expansion card through the

back-panel opening.

Release the expansion-card bracket by loosening the thumbscrew on the back

panel and rotating the latch away from the expansion-card bracket.

Five-Volt Riser Board Installation

1-1