Dell PowerEdge 5160 Panduan Instalasi - Halaman 18

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Server Dell PowerEdge 5160. Dell PowerEdge 5160 20 halaman. Installing the external drive bay
Juga untuk Dell PowerEdge 5160: Panduan Instalasi (42 halaman), Panduan Instalasi (28 halaman), Manual Pembaruan (8 halaman), Pembaruan Informasi (8 halaman), Panduan Pengguna (42 halaman), Pemasangan Rak (34 halaman), Panduan Pemasangan Perangkat Keras (40 halaman), Panduan Instalasi (36 halaman)

Halaman Cetak
Dell PowerEdge 5160 Panduan Instalasi
(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\SlimFast\ts\ProcUpgrade\028WD\028wdeb0.fm
1-14
Microprocessor Upgrade Installation Guide
5.
Pivot the retention clips away from the guide-bracket assembly.
6.
Slide the terminator card out of the guide-bracket assembly.
,QVWDOOLQJ D 7HUPLQDWRU &DUG
To install a terminator card in the guide-bracket assembly, perform the following steps:
1.
Slide the terminator card into the guide-bracket assembly until the edge connec-
tor on the terminator card is firmly seated in the connector on the system board.
2.
Place the retention clips on each end of the guide bracket in the notches on the
ends of the guide bracket, and then close the two latches to secure the termina-
tor card in the bracket.
5HPRYLQJ WKH 6(& &DUWULGJH DQG +HDW 6LQN $VVHPEO\
To remove the SEC cartridge and heat sink assembly, perform the following steps.
,QVWDOODWLRQ DQG 7URXEOHVKRRWLQJ *XLGH
1.
Turn off the system, including any attached peripherals, and disconnect the AC
power cable from its power source.
*XLGH
2.
Remove the computer cover.
3.
Remove the cooling shroud.
4.
Lift the latches on each end of the guide-bracket assembly.
5.
Pivot the retention clips away from the guide-bracket assembly.
6.
Slide the SEC cartridge and heat sink assembly out of the guide-bracket
assembly.
DELL CONFIDENTIAL - Preliminary
'HOO 3RZHU(GJH 6\VWHPV
,QVWDOODWLRQ DQG 7URXEOHVKRRWLQJ
9/11/00