Dell PowerEdge 6800 Panduan Pemecahan Masalah - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Pemecahan Masalah untuk Server Dell PowerEdge 6800. Dell PowerEdge 6800 16 halaman. Installation and troubleshooting guide (.htm)
Halaman Cetak5 Remove the tower front panel:
Using a T-10 Torx driver, remove the 4 flat-head screws located between the drive bays on
a
the tower front panel. See Figure 1-5.
Using a T-15 Torx driver, remove the 21 pan-head screws that secure the tower front panel
b
to the drive tray.
Installing the Rack Front Panel and Control Panel Assembly
1 Install the rack front panel:
Orient the system so that the front of the system hangs over the edge of the table as
a
shown in Figure 1-5.
Using a T-15 Torx driver, install the 21 pan-head screws (supplied in the conversion kit)
b
that secure the rack front panel to the drive tray.
Using a T-10 Torx driver, install the additional 4 flat-head screws (supplied in the
c
conversion kit) into the screw holes located between the drive bays on the rack front
panel.
NOTE:
The control panel assembly's LCD board and the I/O board are the same for both the tower and
rack systems. Only the metal carrier bracket is different and must be replaced when converting your
tower system to a rack system.
2 Replace the metal bracket in the control panel assembly. See Figure 1-6.
Using a #2 Phillips screwdriver, remove the screw that secures the I/O board to the
a
existing control panel bracket.
Using a #2 Phillips screwdriver, remove the two screws that secure the LCD board to the
b
bracket.
Detach the control-panel front plate from the bracket by releasing the three tabs on the
c
inside of the plate.
Snap the front plate onto the front of the new bracket included in your conversion kit.
d
Align the I/O board on the replacement bracket.
e
Using a #2 Phillips screwdriver, install the screw that secures the I/O board to the
f
replacement bracket.
Align the LCD board on the replacement bracket.
g
Tower-to-Rack Conversion Guide
13