Dell PowerEdge FN410S Panduan Memulai - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Memulai untuk Server Dell PowerEdge FN410S. Dell PowerEdge FN410S 29 halaman. I/o aggregator
Halaman Cetak
Installation
This switch installation procedure assume the Dell PowerEdge FX2 server chassis is installed correctly. For
complete instructions for installation, refer to the Dell PowerEdge FX2 server chassis Installation Guide.
•
AC/DC power cord — The cord reaches from the power outlet to the Utility-panel connector.
•
Cabling — The cabling is routed to avoid sources of electrical noise such as radio transmitters,
broadcast amplifiers, power lines, and fluorescent lighting fixtures.
•
Airflow — The airflow around the switch and through the vents is unrestricted.
Unpacking the Aggregator
When unpacking the aggregator, ensure that the following items are included:
•
One FN I/O Aggregator
•
One USB type A-to-DB-9 female cable
•
Getting Started Guide
•
Safety and Regulatory Information
•
Warranty and Support Information
•
Software License Agreement
Unpacking Steps
NOTE: Before unpacking the aggregator, inspect the container and immediately report any
evidence of damage.
1.
Place the container on a clean, flat surface and cut all straps securing the container.
2.
Open the container or remove the container top.
3.
Carefully remove the switch from the container and place it on a secure and clean surface.
4.
Remove all packing material.
5.
Inspect the product and accessories for damage.
Installation
4
13