DH Lifelabs Sciaire Pro Ceiling Buku Petunjuk - Halaman 8

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Peralatan Rumput dan Taman DH Lifelabs Sciaire Pro Ceiling. DH Lifelabs Sciaire Pro Ceiling 10 halaman.

Halaman Cetak

Cleaning and Maintenance

WARNING: THE DEVICE MUST BE ISOLATED FROM THE POWER SUPPLY

BEFORE ANY CLEANING AND MAINTENANCE TAKES PLACE.

CAUTION: ALWAYS WEAR SUITABLE GLOVES WHEN CLEANING.

• Use a dry cloth to clean the exterior of the device. Do not use any chemicals

or cleaners.

• The device may not operate effectively in very low temperatures. The

device can be damaged when exposed to sub-freezing temperatures.

Suggest operating temperature: -4°F~86°F, Suggest storage temperature:

-40°F~104°F.

• To extent the effective of the device, check the air inlet grill and air outlet

grills from time-to-time and clean them with a standard vacuum.

• Visually inspect the interior compartment of the device when the inside is

empty during the filter replacement process, if particulate has accumulated

in the device, clean the interior compartment of the device with a standard

vacuum.

• The power supply is specially adapted, please do not replace the

power supply without permission. The use of accessory equipment not

recommended by the manufacturer may cause an unsafe condition.

Contact a qualified electrician or customer support for cleaning and

maintenance instruction if your are unfamiliar with the device.

HEPA Filter Replacement

The filter should be replaced every 12 months or whenever indicated

by the flashing blue indicator. Depending on usage and contaminates

in the environment, the filter may need to be replaced before the

default cycle expires. When the air volume is reduced, replace the filter

to a new one.

Only use genuine DH Lifelabs Filter with your device. Use of any

other filter may compromise the proper operation of your device and

potentially void your warranty.

HEPA Filter Part No.: CA17FT-1

Contact customer support if you need to replace the filter.

NOTE: The HEPA filter is not washable. DO NOT immerse it in

water.

1. Make sure the device is power off.

2. Move the left and right pegs on the air intake grill to the middle to

release the air inlet grill.

3. Gently pull the air intake grill straight down, to access the filter.

Remove the used HEPA filter out by the pull tabs.

Install a new HEPA filter inside the device. Ensure that any plastic

wrapping is removed from the filter prior to installing them in the

device.

NOTE: Ensure that the pull tabs are facing outward to facilitate

filter removal later.

5. Replace the air inlet grill back, and the two pegs will be locking in

place directly.

6. Turn on the device. After replacing the filter, press and hold down

the RESET button for 3 seconds to reset the filter life countdown. Once

filter reset is done, the flashing blue indicator light will changed to

green solid light.

HEPA filter replacment

Indicator

Blue light flashing