Dell PowerEdge M520 Panduan Pengguna - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Server Dell PowerEdge M520. Dell PowerEdge M520 26 halaman. Dell poweredge blade servers getting started guide
Juga untuk Dell PowerEdge M520: Pembaruan Informasi (38 halaman), Catatan Rilis (27 halaman), Manual (25 halaman), Panduan Pengguna (23 halaman), Panduan Informasi Penting (35 halaman), Manual Pembaruan (32 halaman), Manual Pembaruan (28 halaman), Panduan Pengguna (22 halaman), Panduan Memulai (12 halaman), Panduan Teknis (46 halaman), Panduan Teknis (45 halaman), Panduan Portofolio (27 halaman), Panduan Memulai (14 halaman), Panduan Memulai (12 halaman)

Dell 10Gb Ethernet Pass Through II

# login admin

& show image ver

Software image version: X.X.XXX-<date stamp>

Component #1 firmware version: Y.Y.YYY

Component #2 firmware version: Y.Y.YYY

Component #3 firmware version: Y.Y.YYY

& login user

3.5.2

copy image from-file

Synopsis:

copy image from-file [device_number]

Description:

Update the firmware on the 10GbE PTM. Immediately after running this command, the

CLI waits for the user to send the firmware image using the ZModem protocol. To abort

this operation, use CTRL-C. For additional details on the firmware update procedure refer

Section 4, "Operating Procedures," on page 19

ADMIN:

device_number: When this option is specified, the command will update the firmware of a

single PhyX® device, or the micro-controller software. This option specifies the device

onto which to upload the image (0..3, where 0 indicates micro-controller image)

Example:

# copy image from-file

# login admin

& copy image from-file 2# Update image on device no. 2

& login user

3.6

Device Commands

3.6.1

show device temp (ADMIN)

Synopsis:

show device temp device_number

Description:

Show the temperature of the specified device:

>device_number: device number from which to read temperature (1..3)

Example:

& show device temp 1

Device no. 1 temperature: 42 [Celsius]

Rev 1.00