Dell PowerEdge M915 Manual - Halaman 23

Jelajahi secara online atau unduh pdf Manual untuk Server Dell PowerEdge M915. Dell PowerEdge M915 25 halaman. Dell poweredge blade servers getting started guide
Juga untuk Dell PowerEdge M915: Catatan Rilis (27 halaman), Panduan Pengguna (23 halaman), Panduan Informasi Penting (35 halaman), Panduan Memulai (12 halaman), Panduan Memulai (12 halaman), Panduan Pemilik (3 halaman), Panduan Portofolio (27 halaman), Panduan Memulai (14 halaman), Panduan Memulai (12 halaman)

After loading the .pfw file, both the software and firmware will be programmed onto the 10GbE

PTM.

The update process takes a few minutes.

Note:

At the end of this process, the following message will be displayed at the prompt:

# Received update image successfully. Changes will take effect after

next reboot.

Exit the 10GbE PTM CLI to the CMC command line. Run:

Step 6.

# exit

Power cycle the 10GbE PTM for the firmware to take effect. From the CMC command line type

Step 7.

the following command:

$ racadm chassisaction -m switch-<n> powercycle

Wait for 20 seconds, and then connect to the 10GbE PTM. Run:

Step 8.

$ connect switch-<n>

You will be able to view the progress of the SW update.

At the end of a successful SW update process, the following message will be displayed:

Step 9.

FW updated successfully!

Welcome to the Dell 10GbE PTM Management Console firmware X.X.XXX-<date

stamp>

Step 10.

# login admin

To confirm that all PhyX® chips have the same firmware version, run the command:

Step 11.

& show image ver

Software image version: X.X.XXX-<date stamp>

Component #1 FW version: Y.Y.YYY

Component #2 FW version: Y.Y.YYY

Component #3 FW version: Y.Y.YYY

Rev 1.00