Dell Poweredge metered Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Server Dell Poweredge metered. Dell Poweredge metered 8 halaman. Cabling poweredge t610
Juga untuk Dell Poweredge metered: Manual (20 halaman), Manual (20 halaman), Manual (17 halaman), Manual (12 halaman), Manual (10 halaman), Manual (10 halaman), Manual (9 halaman), Manual (9 halaman), Manual (10 halaman), Manual (12 halaman), Manual (12 halaman), Manual (11 halaman)

Dell Poweredge metered Manual
Cable Routing Procedures for Dell™ PowerEdge™ T610 Systems

1.2 Routing the Power Cables Through the Strain Reliefs

After you have installed the tray and cables, route the power cables through the strain reliefs located
on the power supply handles as shown in Figure 2.

Figure 2: Routing Power Cables Through the Strain Reliefs

1.3 Installation of the CMA

The CMA can be installed on either the rear right or rear left side of the rails. Mounting the CMA on the
side that is opposite of the power supplies (right-side mount) is recommended; otherwise, the CMA
must be partially disconnected in order to remove the lower power supply. Refer to Section 3 for
details on power supply replacement.
NOTE: For guidelines on how to route cables within the rack, refer to the Dell
Rack Enclosures
white paper
NOTE: If you are installing fiber-optic cables in the CMA, a cable bend radius of at least 1 inch must be
maintained throughout the length of the cable
on the exterior of the cable bundle to increase the bend radius of the fiber-optic cables through the
CMA. Additionally, a large amount of slack at the entrance and exit of the CMA is recommended.
1.
Install the CMA on either the rear right or rear left side of the rails by attaching both CMA housings
to the attachment brackets on the rails.
2. Route the cables through the CMA while avoiding twisting the cables. Use the hook and loop
straps on the CMA to secure the cables. See Figure 3.
3. If the cable bundle includes a keyboard, video, and mouse (KVM) dongle, place the dongle inside
the CMA basket.
4. Once you have routed all the cables through the CMA, dress the cable slack between the back of
the system and the entrance of the CMA using the tie wraps (shown in yellow in all illustrations)
provided in the CMA kit.
.
.
It is recommended that fiber-optic cables be routed
Best Practices Guide for
Page 3