ensto EFPPH 8 Panduan Petunjuk Pemasangan dan Pengoperasian - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan dan Pengoperasian untuk Pemanas ensto EFPPH 8. ensto EFPPH 8 20 halaman.
Halaman Cetak
ENG
Installation and Operation Instructions
Applications
Plug'n Heat cables are used in piping, water meters and other equipment to prevent freezing. The cable is
equipped with a plug for connection to an earthed socket. In permanent installations the cable should be
controlled by either an all-pole switch or a thermostat and equipped with a strain relief.
Safety instructions
•
Children aged from 8 years above and persons with reduced capabilities may use this appliance only
if they have been given supervision or instructions concerning the use of the appliance in a safe way
and understand the hazards involved.
•
Children must not clean the appliance or do any maintenance work without supervision.
•
Children must not play with the appliance.
•
The instruction manual must be stored in a safe location and be available for future installation and
service.
General installation instructions
•
Plug'n Heat cables can be used both indoors and outdoors. The heating cable is self-regulating and
under normal circumstances its temperature will not rise above 60ºC. The cable may be installed
directly on top of either plastic or metal piping underneath the insulation. It can also be installed
directly underwater. The cable can be laid so that it winds over itself.
•
The cable must not be installed in a situation in which the protective sheath may be exposed to phy-
sical wear. For example, it should not be compressed, laid against sharp edges, placed under tension,
or subject to constant chafing.
•
The minimum bending radius is 25 mm.
•
The joint between the connecting cable and the heating cable must not be bent.
•
The connection cable and the joint between the connection cable and the heating cable must not
be pushed into the pressure bushing.
•
A residual circuit breaker must be used according to the local installation regulations.
•
The minimum installation temperature for the cable is – 15 °C.
•
The cable should be connected to the 230 V mains supply through a protective earth socket.
Observe when installing the self-regulating heating cable Optiheat 10 inside a water pipe!
The cable end can be pushed through the rubber seal of the pressure bushing using soap. The cable should
be cautiously pushed through the rubber seal into the water pipe in order to avoid damaging the cable
sheath. The threads and other sharp parts should be covered with e.g. fabric tape during the installation.
Installation drawings:
1.
Preventing a water meter from freezing up.
2.
The cable installed inside a water pipe using a pressure bushing.
3.
The cable attached to the surface of a pipe using a heat resistant tape.
Properties of the cable element:
Plug'n Heat
type
EFPPH 2
EFPPH 3
EFPPH 4
EFPPH 5
6
Length
Power
(m)
W 10 ºC
2,0
20
3,0
30
4,0
40
5,0
50
RAK36 / © Ensto 2018