Dell Wyse ThinOS T10 Panduan Memulai Cepat - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Server Dell Wyse ThinOS T10. Dell Wyse ThinOS T10 8 halaman.
Juga untuk Dell Wyse ThinOS T10: Panduan Memulai Cepat (6 halaman), Panduan Memulai Cepat (6 halaman), Panduan Memulai Cepat (8 halaman), Panduan Memulai Cepat (8 halaman), Panduan Memulai Cepat (6 halaman), Panduan Memulai Cepat (6 halaman)
Halaman Cetak
Setting Up Your Thin Client
Be sure you have read Safety Guidelines before setting up and
operating this product. Refer to the figures and proceed as follows:
1
Make sure the monitor and the thin client are turned off and
disconnected from AC power. Place the thin client on a desk or
use the horizontal stand/bracket for VESA mounting (assemble
with user-provided screws).
2
Make all desired connections (video display and keyboard with
mouse are required). Connection to a 10/100/1000 Base-T
Ethernet network is required unless an optional WiFi network
adapter is used for wireless connection to a network. Additional
connections of peripheral devices may be made to the other
ports.
3
Connect the power adapter to the thin client power input
before connecting to a 100-240V AC, 50-60 Hz electrical
outlet. Wait until the initialization sequence is completed (the
activity light will go off), and then press the power button on the
thin client to apply power.
Safety Guidelines
Improper connection, mounting, or use of this product could result
in component failure or undesired interference. Read the following
guidelines before setting up and operating the device.
Setup
Do not connect to AC power until all other connections
(including the power adapter) are made. Connecting or
disconnecting components or equipment on the back panel
when the device is receiving AC power can cause power
surges and damage the device.
Do not force a connector into its socket. If any undue
resistance is encountered, ensure that the connector is
correctly oriented to the receptacle.
For wireless usage and requirements, refer to the regulatory
notices in the device's documentation.
Venting and Care
Mount the device only as shown or in accordance with the
instructions provided with Dell Wyse-approved mounting
accessory kits. Improper orientation could restrict airflow of
heat from the device and damage it.
Allow sufficient space around the device for ventilation; do
not place the device in any enclosure that restricts airflow
around the device; do not place any objects on the device or
block the vent outlets.
For environmental operating specifications, locate your
product and download the Fact Sheet using the Cloud clients
tab at www.dell.com/wyse/T10.
Power Sources
For regulatory compliance use only the power adapter that
comes with your device or a Wyse-approved equivalent. For
proper replacement compare the labels on both device and
power adapter to ensure that their voltages match.
WARNING:
Use of any other power adapter may damage
your device or the power adapter. The damage caused by an
improper power adapter is not covered by warranty.
Accidental loss of power can damage the device. Avoid
connecting it to any power outlet which can be accidentally
switched off. Do not hard reset the device by holding down
the power button during normal operation.
When turning off the device, be sure to perform a complete
shutdown (via the user interface or a light press on the power
button). Do not disconnect the AC power cord, DC power
cord, or shut off power at a circuit breaker (including power
strips), etc., to turn off the device.
Surge protectors for electrical devices are recommended in
areas of lightning. However, when lightning is occurring, your
equipment should be properly shut down and unplugged
from AC power until the storm has passed.
Be very careful to not interrupt power while the device is
downloading a software update.
Battery
The device contains an internal button cell battery replaceable by
Dell Wyse or one of our Authorized Service Centers. For service,
visit www.dell.com/support/.
WARNING:
There is a risk of explosion if the battery is
replaced by an incorrect type. Always dispose of used
batteries according to the instructions accompanying the
battery.
WARNING:
Perchlorate Materials - Special Handling May
Be Required under California Code of Regulations, title 22.
(Only required within the USA.)
Need more information?
Dell Reference Guides - Documentation is available at:
www.dell.com/wyse/manuals
Dell Support - Latest software images are available at:
www.dell.com/wyse/downloads
Dell Device Manager - Information about Wyse remote
management software is available at: www.dell.com/wyse/WDM
Dell WSM - Information about Dell WSM software is available at:
www.dell.com/wyse/WSM
Dell and the Environment - Information about Wyse compliance
with RoHS and with the Waste Electrical and Electronic Equipment
(WEEE) is available at: www.dell.com/environment
Dell and Recycling - Information about recycling unwanted Dell
product within the United States is available at:
www.dell.com/recycling
Dell Warranty - The standard warranty is three years from the date
of purchase.
____________________________________________________________________
Copyright © 2014 Dell Inc. All rights reserved.
This product is protected by U.S. and international copyright and intellectual
property laws. Dell and the Dell logo are trademarks of Dell Inc. in the United
States and/or other jurisdictions. All other marks and names mentioned
herein may be trademarks of their respective companies.
Sept 2014
Dell PN: GTY3M Rev: A00