Dell E2222H Panduan Servis - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Servis untuk Monitor Dell E2222H. Dell E2222H 15 halaman. Teardown instruction
Juga untuk Dell E2222H: Panduan Pengguna (49 halaman), Panduan Servis yang Disederhanakan (12 halaman), Panduan Servis (15 halaman), Petunjuk (3 halaman)

Halaman Cetak

NOTE:

This "Disassembly and Assembly Procedures" is for EMEA only,

not for other regions. Please note that Dell will deem warranty void

if any disassembly is done on the monitors.

Tool Required:

List the type and size of the tools that would typically can be

used to disassemble the product to a point where components

and materials requiring selective treatment can be removed.

Tool Description:

- Screwdriver(Phillip head) #1

- Screwdriver(Phillip head) #2

- Penknife

- Soldering iron and absorber

5.1 Disassembly Procedures:

Remove the monitor stand base:

1. Place the monitor on a soft cloth or cushion.

2. Remove VESA cover to access the release button.

3. Use a long and thin screwdriver to push the release

latch located in a hole just above the stand.

4. Once the latch is released, remove the base away

from the monitor.

Use a Philips-head screwdriver to remove 6pcs

screws for unlocking mechanisms.

(No.1~4 screw size=M4x11; Torque=11 1kgfxcm;

No.5~6 screw size=M4x6; Torque=11 1kgfxcm)

Turn over the LCD monitor to let the screen faced

up, place a cloth on the panel where you are working

on to protect the panel. Continually, wedge your

fingers between the front bezel and the panel in

order of arrow preference for unlocking

mechanisms. Turn over the LCD monitor to let the

screen faced down and then remove the rear cover.

5. Disassembly and Assembly Procedures

Disconnect the function key cable away from the

connector of the board, then tear off 3pcs adhesive

tape for releasing the function key board.

Tear off 1pcs aluminum foil on the back of the panel

lamp cable for unlocking panel lamp cable, and then

disconnect the panel lamp cable away from the

connector of panel module.

Use a Philips-head screwdriver to remove 2pcs

screws for unlocking the bracket with panel module.

Use a Hex-head screwdriver to remove 2pcs screws

for unlocking the VGA connector.

(No.1~2 screw size=M3x2.6, Torque=4 0.5kgfxcm;

No.3~4 screw size=M3x8, Torque=6

kgfxcm)

±0.5