Dell DL4300 Panduan Penyebaran - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Penyebaran untuk Penyimpanan Dell DL4300. Dell DL4300 33 halaman.
Juga untuk Dell DL4300: Memulai (2 halaman), Memulai dengan Sistem Anda (2 halaman), Memulai dengan Sistem Anda (2 halaman)

Halaman Cetak
Dell DL4300 Panduan Penyebaran
virtual machines and back up a smaller number of agent machines, you can allocate more resources for
larger VMs.
When you select the Appliance tab, the AppAssure Appliance software locates the available storage space
for all supported controllers in the system and validates that the hardware meets the requirements.
To complete disk provisioning for all available storage:
1.
In the Appliance tab, click Tasks → Provisioning.
The Provisioning screen displays estimated capacity for provisioning. This capacity is used to create
a new AppAssure Repository.
CAUTION: Before proceeding ensure Step 2 through Step 4 is followed in this procedure.
2.
Open the Provisioning Storage window by clicking Provision in the Action column next to the
storage that you want to provision.
3.
In the Optional Storage Reserve section, select the box next to Allocate a portion of the storage
being provisioned for Standby Virtual Machines or other purposes and indicate a percentage of
storage to allocate. Otherwise, the percentage of storage indicated in the Optional Storage Reserve
section will be taken from all of the attached disks.
4.
Click Provision.
Configuring the DL4300 using fibre channel storage
(optional)
The DL4300 high-capacity edition offers a fibre channel HBA storage option allowing for creation of
repositories using fibre channel storage arrays.
NOTE: If the fibre channel configuration is ordered it will replace the slotted H830 PERC SAS
adapter.
NOTE: For prerequisites, assumptions, and detailed information on the following steps, see the
DL4xxx — Fibre Channel Implementation whitepaper located at dell.com/support/home .
To integrate and configure the DL4300 using the fibre channel storage:
1.
Connect the DL4300 fibre channel HBA to a SAN switch.
2.
Install either the Qlogic or the Emulex HBAs management software for any adapter that was ordered
with the system.
3.
Install the storage array multi-path software.
4.
Perform the fibre channel zoning.
5.
Create a fibre channel LUN to be assigned and used as a DL4300 repository.
6.
Mount the fibre channel storage LUN.
7.
Configure the DL4300 fibre channel storage as a backup repository.
17