Dell DX6004S Panduan Instalasi dan Konfigurasi - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Konfigurasi untuk Penyimpanan Dell DX6004S. Dell DX6004S 35 halaman. Document
Juga untuk Dell DX6004S: Panduan Tambahan (4 halaman), Panduan Pengguna (46 halaman), Panduan Penyiapan dan Konfigurasi (43 halaman), Panduan Memulai (28 halaman), Pemberitahuan (28 halaman), Pemberitahuan (20 halaman), Ikhtisar (19 halaman), Panduan Konfigurasi (9 halaman), Panduan Konfigurasi (9 halaman), Catatan Rilis (8 halaman), Panduan Konfigurasi (7 halaman), Catatan Rilis (6 halaman), Catatan Rilis (5 halaman), Catatan Rilis (5 halaman), Panduan Memulai (49 halaman)

where 172.20.0.0 is the desired new internal network interface.

Best practice is to reboot the DX Storage cluster from the DX Storage admin console and then

run the changeinternalnetwork script while the cluster is rebooting so that when the nodes come

back online they are assigned a new IP address from the new internal network interface range.

Alternatively, administrators may run the script and then manually power cycle the nodes; the DX

Storage admin console will no longer be able to route the reboot request after the internal network

has been updated. Several CSN processes, including the NTP server and DX Content Router

Publisher and Replicator, will be restarted when the script completes. After the Primary CSN has

changed its internal network and the storage cluster is back online, the Secondary CSN should also

have its internal network changed to the same as the Primary.

3.2. Modifying SNMP Access

The CSN installs the Net-SNMP command line tool for use in collecting SNMP data from the MIB.

The tool utilizes standard SNMP commands like 'snmpwalk', 'snmpget' and 'snmpset'. For read-

only commands (snmpwalk, snmpget), the CSN expects a password of 'public' by default. For write

commands, it expects a 'private' password by default. The default passwords may be updated from

the SNMP Access link under the Cluster Services tab of the CSN Console:

To update the version of DX Storage software being used in the storage cluster, you must install the

new rpm using the following command from a standard RHEL terminal window:

yum install [new DX Storage version]

After the install, a new DX Storage software version will appear on the Netboot Management page

of the Cluster Services tab of the CSN Console:

Version 2.0

December 2010