Dell DX6012S Ikhtisar - Halaman 11

Jelajahi secara online atau unduh pdf Ikhtisar untuk Penyimpanan Dell DX6012S. Dell DX6012S 19 halaman. Rack installation instructions — static rails
Juga untuk Dell DX6012S: Panduan Tambahan (4 halaman), Petunjuk Pemasangan Perangkat Keras (2 halaman), Panduan Pengguna (46 halaman), Panduan Penyiapan dan Konfigurasi (43 halaman), Panduan Instalasi dan Konfigurasi (35 halaman), Panduan Memulai (28 halaman), Pemberitahuan (28 halaman), Pemberitahuan (20 halaman), Panduan Konfigurasi (9 halaman), Panduan Konfigurasi (9 halaman), Catatan Rilis (8 halaman), Panduan Konfigurasi (7 halaman), Catatan Rilis (6 halaman), Catatan Rilis (5 halaman), Catatan Rilis (5 halaman), Panduan Memulai (47 halaman), Instalasi (2 halaman), Pemasangan Rak (2 halaman)

Chapter 2. Installing, Configuring and Running SCSP

Proxy

The SCSP Proxy installs as an RPM and is managed very similarly to other RPM packages. If

the SCSP Proxy is being utilized on a Cluster Services Node (CSN), the installation and base

configuration are performed automatically as part of CSN setup. See the CSN Installation and

Configuration Guide for complete details of customizing the SCSP Proxy on the CSN.

SCSP Proxy has been developed and tested with 64-bit Red Hat Enterprise Linux (RHEL) 5.5.

Other RHEL versions or Linux distributions are not currently supported. The information discussed

in this chapter assumes you use a pre-installed RHEL Linux environment.

To install the SCSP Proxy, you must first install prerequisite packages (if required). The following

topics discuss these tasks in more detail:

•

Section 2.2.1, "Installing SCSP Proxy Prerequisites"

•

Section 2.2.3, "Installing or Upgrading the SCSP Proxy Software"

•

Section 2.2.4, "Configuring the SCSP Proxy"

Before you can install the SCSP Proxy, you must verify the following prerequisites are installed:

• Python 2.5

• Python Setuptools 0.6c9

• Twisted 8.2.0

None of the preceding are available as standard RPM packages with RHEL 5.5; however, a Python

2.5-compatible Twisted RPM is located in the /scspproxy directory of this SDK.

If you are installing the SCSP Proxy on a Cluster Services Node (CSN), all of the required RPMs are

installed for you.

If you are installing the SCSP Proxy on a non-CSN system, you can manually install the packages

using commands like the following (in the order shown):

yum -y --nogpgcheck install caringo-3rdparty-Python-2.5.4-x86_64.rpm

yum -y --nogpgcheck install caringo-3rdparty-setuptools-0.6c9-x86_64.rpm

yum -y --nogpgcheck install caringo-3rdparty-Twisted-8.2.0-x86_64.rpm

Before starting your Proxy installation, upgrade to RHEL 5.5 using upgrade utilities provided with the

operating system.

Installing the SCSP Proxy from the SDK is similar to installing the prerequisites because the

procedure is different depending on whether or not you have CSN. To install the SCSP Proxy from

the SDK, do either of the following:

Version 1.2

December 2010