Dell EqualLogic PS Series Panduan Pemilik Perangkat Keras - Halaman 30
Jelajahi secara online atau unduh pdf Panduan Pemilik Perangkat Keras untuk Penyimpanan Dell EqualLogic PS Series. Dell EqualLogic PS Series 50 halaman. Storage arrays
Juga untuk Dell EqualLogic PS Series: Menyiapkan (2 halaman), Panduan Pemilik Perangkat Keras (48 halaman), Pemeliharaan Perangkat Keras (46 halaman)
Halaman Cetak
PS6610 Hardware Owner's Manual
1. Attach an electrostatic wrist strap or similar protective device. See
6.
2. Pull up on the orange release tab (callout 2 in
3. Slide the control module (callout 1 in
controller. The lever should swing smoothly until it is in the locked position.
4. Rotate the lever inward, which pushes the control module completely into the slot. The latch on
the lever will snap into place.
5. Connect all cables (network and serial port).
6. If the array was shut down, turn on power to the array.
7. Make sure the control module is operational. See
The Type 18 control module contains an integral battery assembly used in the cache-to-flash fea-
ture of the control module. If the Group Manager GUI or CLI indicates a battery failure, the bat-
tery must be replaced.
24
Figure 15: Correct Control Module Orientation
Figure
Figure 16: Installing a Control Module
3 Control Module Maintenance
Hardware Protection on page
Figure
16) and swing the lever out.
16) into the chassis until it is even with the installed
Interpreting Control Module LEDs on page
16.