Dell PowerEdge 4400 Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penyimpanan Dell PowerEdge 4400. Dell PowerEdge 4400 42 halaman. Wake-on-lan (wol) support on dell servers
Juga untuk Dell PowerEdge 4400: Panduan Instalasi (42 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (28 halaman), Pemasangan Rak (37 halaman), Manual Pembaruan (8 halaman), Pembaruan Informasi (8 halaman), Pemasangan Rak (34 halaman), Panduan Pemasangan Perangkat Keras (40 halaman), Panduan Instalasi (36 halaman), Manual (15 halaman)

Dell PowerEdge 4400 Panduan Pengguna
Dell™ PowerEdge™6300
and 4x00 Systems
SCSI Backplane Option
This document describes the optional small computer system interface (SCSI) back-
plane for the Dell PowerEdge 6300 and 4x00 systems.
The 1 x 8 SCSI backplane provides hot-pluggable Ultra2/LVD SCSI connections for up
to eight 1-inch hard-disk drives in the system's internal drive compartment. Except for
the added SCSI connections provided on the board, the 1 x 8 backplane is identical to
the 1 x 6 backplane in features and functionality (for example, the cable connectors on
both backplanes are identical). For a description of the SCSI backplane, refer to your
system User's Guide and Installation and Troubleshooting Guide.
NOTE: Before you install the 1 x 8 backplane, verify that your system chassis supports
it. Check the back of your system for a label (located between the connectors and the
first power supply) that specifies that your chassis supports the 1 x 8 backplane. If you
do not find a label, you may not be able to use the 1 x 8 backplane in your system
chassis. Contact your Dell representative for further information and instructions.
Installing a SCSI Backplane
WARNING: The power supplies in this computer system produce high volt-
ages and energy hazards, which can cause bodily harm. Only trained
service technicians are authorized to remove the computer cover and
access any of the components inside the computer.
NOTE: You can use only 1-inch hard-disk drives with the 1 x 8 backplane. You
cannot use 1.6-inch hard-disk drives with the 1 x 8 backplane. To work with the
1 x 8 backplane, you need to convert the drive carriers to the 1-inch width by removing
the spacer insert that fastens to each carrier adjacent to the carrier release handle.
To replace a SCSI backplane board with a different backplane board, perform the fol-
lowing steps.
support.dell.com
Dell PowerEdge 6300 and 4x00 Systems SCSI Backplane Option
1-1