Dell PowerEdge Express Flash NVMe PCIe SSD Panduan Pengguna - Halaman 23

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penyimpanan Dell PowerEdge Express Flash NVMe PCIe SSD. Dell PowerEdge Express Flash NVMe PCIe SSD 32 halaman.

Halaman Cetak

Entering The HII Configuration Utility

To enter the HII Configuration Utility:
1.
Turn on the system.
2.
Press <F2> during system startup to enter the system setup.
3.
Navigate to the Device Settings option.
4.
Select the desired NVMe PCIe SSD to view its HII configuration page. Each device includes an entry
such as: PCIe Solid State Drive in Slot X in Bay Y: Dell NVMe PCIe SSD
Configuration Data.

Viewing Physical Device Properties

Follow the steps to view physical device properties:
1.
Select View Physical Device Properties in the HII Configuration Utility.
2.
Press <Esc> to return to the previous screen.
3.
To exit the PCIe SSD HII Configuration utility, click Exit in the top-right corner of the System Setup
menu.

Erasing Physical Devices

CAUTION: Performing a cryptographic erase on an NVMe PCIe SSD results in permanent loss of
all data on the NVMe PCIe SSD.
NOTE: During a cryptographic erase, the host cannot access the NVMe PCIe SSD.
NOTE: If the system reboots or experiences a power loss during a cryptographic erase, the
operation aborts. Reboot the system and restart the process.
NOTE: The cryptographic erase operation takes a few seconds to complete. While this operation is
in progress, you cannot navigate away from this page.
To perform a cryptographic erase on an NVMe PCIe SSD from the HII Configuration utility, do the
following:
1.
Navigate to the Select Physical Device Operations menu of the HII Configuration Utility.
2.
Select Cryptographic Erase.
The following warning message displays: "Performing a cryptographic erase results in
permanent loss of all data on the device. Do you want to continue?"
You can select Yes or No.
3.
Press <Esc> to return to the previous screen.
4.
To exit the HII Configuration Utility, click Exit in the top-right corner of the System Setup menu.

Setting LED Blinking

The LED blink option allows you to identify a physical device in the system. To start or stop the feature:
1.
Navigate to the Select Physical Device Operations menu in the HII Configuration Utility.
2.
Select the Blink option to begin LED blinking, or the Unblink option to end LED blinking.
3.
Press <Esc> to return to the previous screen.
4.
To exit the HII Configuration Utility, click Exit in the top-right corner of the System Setup menu.
23