Dell PowerVault 221S Panduan Servis - Halaman 22
Jelajahi secara online atau unduh pdf Panduan Servis untuk Penyimpanan Dell PowerVault 221S. Dell PowerVault 221S 33 halaman. Dell powervault 220s and 221s systems scsi drive enclosure
Juga untuk Dell PowerVault 221S: Manual (44 halaman), Pemberitahuan (28 halaman), Memperbarui Firmware (14 halaman)
Halaman Cetak
Removing and Replacing Parts : Dell PowerVault 220S and 221S Systems Service Manual
NOTICE:
To avoid damage, never leave a drive carrier partially removed from the storage system. Rotating a carrier handle next to an unseated drive carrier will result in serious
damage to the unseated drive carrier.
NOTICE:
To avoid data loss when removing a hard drive from an active RAID array, you must first use the array management software to prepare the drive for removal. See your
array management software documentation for more information.
NOTICE:
Always wear a wrist grounding strap when handling equipment with static-sensitive components.
1. Use your array management software to prepare the drive for removal.
2. Wait until the LED indicators on the drive carrier stop flashing.
If you have a tower system, open the front bezel using the keylock mechanism on the top of the bezel.
4. Squeeze the release mechanism on the front of the hard-drive carrier (see
Figure 12. Installing and Removing Hard Drives
5. Open the hard-drive carrier handle.
6. Gently but firmly pull the hard-drive carrier from its slot.
NOTE:
If the wrong drive is inadvertently removed, your array management software issues a message that a logical disk has failed after I/O has started. For more information,
see your array management documentation.
Installing Hard Drives
Your hard-drive carrier may include access pins that prevent the carrier from being inserted into a non-SCSI drive slot.
NOTICE:
To ensure proper airflow for system cooling, each slot should contain either an active drive and drive carrier or a carrier blank.
NOTICE:
Always wear a wrist grounding strap when handling equipment with static-sensitive components.
1. If your drive carrier is already configured for SCSI drive installation, or if your drive carrier did not include access pins, go to
Perform the following steps to set the access pins on your drive carrier for SCSI drive installation:
file:///C|/Users/rishi_sood/Desktop/220s/en/sm/remove.htm[3/7/2013 12:09:15 PM]
Figure
12).
1 chassis face plate
2 carrier guide rail
3 drive carrier handle
4 carrier release mechanism
step
2.