Dell PowerVault MD3200i Series Panduan Penyebaran - Halaman 18

Jelajahi secara online atau unduh pdf Panduan Penyebaran untuk Penyimpanan Dell PowerVault MD3200i Series. Dell PowerVault MD3200i Series 41 halaman. Storage arrays
Juga untuk Dell PowerVault MD3200i Series: Manual Pembaruan (32 halaman), Petunjuk Pemasangan Rak (2 halaman), Panduan Pengguna (46 halaman), Matriks Dukungan (12 halaman), Panduan Instalasi (18 halaman), Pembaruan Informasi (1 halaman), Matriks Dukungan (11 halaman), Matriks Dukungan (17 halaman), Buku Panduan Teknis (38 halaman), Buku Putih (22 halaman), Manual (16 halaman)

Dell PowerVault MD32xxi Configuration Guide for VMware ESX4.1 Server Software

esxcfg-nics –l

The output will look similar to this:

Name PCI

vmnic0 03:00.00 bnx2 Up 1000Mbps Full

This will list all of the adapters in the system. Assign the NICs that are physically connected to the SAN

infrastructure and to the vSwitch. The following command assumes that we are assigning vmnic1, vmnic2,

and vmnic3 to the vSwitch.

esxcfg-vswitch –L vmnic1 vSwitch2

esxcfg-vswitch –L vmnic2 vSwitch2

esxcfg-vswitch –L vmnic3 vSwitch2

Once again, to verify the configuration type the following command to list the vSwitch information:

esxcfg-vswitch –l

Your output will look similar to the following. Note the new vmnics that were assigned to the vSwitch

under uplinks.

Switch Name Num Ports Used Ports Configured Ports MTU Uplinks

vSwitch2

PortGroup Name VLAN ID Used Ports

iSCSI3

iSCSI2

iSCSI1

Adding a NIC can also be configured and verified in the vCenter GUI. Remember that the polling of

vCenter is not instant so a refresh might need to occur to see the latest changes. To configure this same

process from the GUI, first navigate to the Networking section on the ESX host you are configuring.

Configuration -> Networking.

From here, click Properties on the vSwitch2.

Driver

Link Speed Duplex MAC Address

MTU

00:21:9b:8b:4b:b0 1500

9000

Uplinks

vmnic1,vmnic2,vmnic3

Page 16